Initial config Dell PowerStore Ensure that your workstation’s network adapter is configured as follows: Configured with a static IP address on the service LAN network (128.221.1.0/24) with no gateway address defined (128.221.1.249; 255.255.255.0; no gateway) Connect your workstation or laptop to the service port on Node B of the base enclosure. In a …
Use the command below to test jumbo frames: Windows: ping {ip_address} -f -l 8972 -l 8972 value is actually equal to 9000 9000 – 20 (20 byte IP header) – 8 (ICMP header) = 8972 Remember the source like Windows is set to 1500 MTU by default so you’ll get “Packet needs to be …
Verifying Multipathing There is a powerful little command line utility that allows pulling a tremendous amount of information regarding multipath disk connections – mpclaim. To check your current policy for your iSCSI volumes: mpclaim -s -d To verify paths to a specific device number: mpclaim -s -d < device number >
vCenter Appliance Network configuration change via command line. Most of the system configuration such as changing the hostname, IP, DNS..etc can be done using VAMI interface (https://vCenterIPorFQDN:5480) however if you see the changes are not taking affect, e.g. changing the DNS IP then following command can be used. · Enable SSH using VAMI interface, select Access tab, click Edit and Enable …
Read more “vCenter Appliance Network configuration change via command line”
Met vriendelijke groet / Kind regards, Alwin Bongers Dustin Server en storage engineer Phone: +31 24 – 209 2612 Mobile: +31 6 – 82 48 60 93 E-mail: Alwin.Bongers@dustin.com Website: www.dustin.nl
1. Enable SSH 2. Set Host in Maintenance mode 3. Select Data Store and upload Offline Bundle 4. Putty to host 5. Determine which VIBs are installed on the host: esxcli –server= software vib list Determine which image profiles are available in the depot.: esxcli –server= software sources profile list –depot=http:/// Update the existing image …
1. Enable SSH 2. Set Host in Maintenance mode 3. Select Data Store and upload Offline Bundle 4. Putty to host 5. Determine which VIBs are installed on the host: esxcli –server= software vib list Determine which image profiles are available in the depot.: esxcli –server= software sources profile list –depot=http:/// Update the existing image …